Supermicro A+ Server 1020A-T, Beige Bedienungsanleitung PDF herunterladen (Seite 39)

Chapter 5: Advanced Serverboard Setup

5-5

5-4 Connecting Cables

Now that the processors are installed, the next step is to connect the cables to

the serverboard. These include the data (ribbon) cables for the peripherals and

control panel and the power cables.

Connecting Data Cables

The ribbon cables used to transfer data from the peripheral devices have been

carefully routed in preconﬁ gured systems to prevent them from blocking the ﬂ ow

of cooling air that moves through the system from front to back. If you need to

disconnect any of these cables, you should take care to reroute them as they

were originally after reconnecting them (make sure the red wires connect to the

pin 1 locations). If you are conﬁ guring the system, keep the airﬂ ow in mind when

routing the cables. The following data cables (with their serverboard connector

locations noted) should be connected. See the serverboard layout diagram in this

chapter for connector locations.

 CD-ROM cable (JIDE#1)

 Floppy Drive cable (JFDD1)

 Serial ATA cables (JS1, JS11, JS12, JS13)

 Control Panel cable (JF1, see next page)

Connecting Power Cables

The H8DAR-T has a 24-pin primary power supply connector "J1B4" at designated

"ATX Power" for connection to the ATX power supply. Connect the appropriate

connector from the power supply to the "ATX Power" connector to supply power to

the serverboard. See the Connector Deﬁ nitions section in this chapter for power

connector pin deﬁ nitions.

In addition, your power supply must be connected to the 8-pin Secondary ATX

Power connection at JPW2. For systems with high load conﬁ gurations, a third

power connector at J32 should also be connected to your power supply.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

Keine Kommentare

Supermicro A+ Server 1020A-T, Beige Bedienungsanleitung Seite 39