Supermicro SYS-5026TI-HTRF Bedienungsanleitung PDF herunterladen (Seite 66)

6-4

SUPERSERVER 5026Ti-HTRF User's Manual

Installing and Removing Hard Drives

Installing a Hard Drive into the Drive Carrier

Empty drive carriers have pre-installed dummy drive trays. This dummy tray needs

to be removed before installing an actual hard drive (see Figure 6-3).

Remove the screws (2) holding connecting the drive tray the carrier.1.

Remove the tray from the carrier.2.

Mounting a Hard Drive in a Carrier

Install the drive into the carrier with the printed circuit board side facing down 1.

so that the mounting holes align with those in the carrier.

Secure the drive to the carrier with six screws, as shown in Figure 6-4.2.

Use the open handle to replace the drive carrier into the chassis. Make sure 3.

to fully close the drive carrier handle.

Be aware that powering down a node will power down all the hard drives

that are logically associated with it (as shown in Figure 6-6).

6-4 Hard Drive Installation/Removal

Overview

The hard drives are mounted in drive carriers to simplify their installation and

removal from the chassis. These carriers also help promote proper airﬂ ow for the

system. For this reason, even empty carriers without drives installed must remain

in the chassis.

Because of their hot-swap capability, you do not need to access the inside of the

chassis or power down the system to install or replace hard drives.

Note: The operating system you use must have RAID support to enable the hot-

swap capability of the hard drives.

Enterprise level hard disk drives are recommended for use in Supermicro

chassis and servers. For information on recommended HDDs, visit the

Supermicro Web site at http://www.supermicro.com/products/nfo/ﬁ les/

storage/SAS-1-CompList-110909.pdf

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 103 104

Keine Kommentare

Supermicro SYS-5026TI-HTRF Bedienungsanleitung Seite 66