Supermicro X9SRH-7F Bedienungsanleitung Seite 26
- Seite / 115
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
1-12
X9SRH Motherboard Series User’s Manual
1-3 Special Features
Recovery from AC Power Loss
Basic I/O System (BIOS) provides a setting for you to determine how the system
will respond when AC power is lost and then restored to the system. You can
choose for the system to remain powered off (in which case you must press the
power switch to turn it back on), or for it to automatically return to a power-on state.
See the Advanced BIOS Setup section to change this setting. The default setting
is Last State.
1-4 PC Health Monitoring
This section describes the PC health monitoring features of the board. All have an
onboard System Hardware Monitoring chip that supports PC health monitoring. An
onboard voltage monitor will scan these onboard voltages continuously: CPU Vcore,
12V Scale, DIMM, 1.5V, 3.3V Vcc(V), Vcc5V, CPU VTT, 3.3VSB, and Battery Volt-
age. Once a voltage becomes unstable, a warning is given, or an error message
is sent to the screen. The user can adjust the voltage thresholds to dene the
sensitivity of the voltage monitor.
Fan Status Monitor with Firmware Control
PC health monitoring in the BIOS can check the RPM status of the cooling fans. The
onboard CPU and chassis fans are controlled by Thermal Management via BIOS
(under the Hardware Monitoring section in the Advanced Setting).
Environmental Temperature Control
The thermal control sensor monitors the CPU temperature in real time and will turn
onthethermalcontrolfanwhenevertheCPUtemperatureexceedsauser-dened
threshold. The overheat circuitry runs independently from the CPU. Once the ther-
mal sensor detects that the CPU temperature is too high, it will automatically turn
on the thermal fans to prevent the CPU from overheating. The onboard chassis
thermal circuitry can monitor the overall system temperature and alert the user when
the chassis temperature is too high.
Note: To avoid possible system overheating, please be sure to provide
adequateairowtoyoursystem.
System Resource Alert
This feature is available when the system is used with Supero Doctor III in
- USER’S MANUAL 1
- X9SRH-7F 1
- X9SRH-7TF 1
- About This Motherboard 3
- Manual Organization 3
- Safety Information 4
- Contacting Supermicro 5
- Table of Contents 6
- •Six (6) SATA cables 15
- •One (1) I/O shield 15
- Important Notes to the User 18
- Socket R 19
- LGA 2011 19
- Motherboard Features 21
- Intel Chipset 24
- 1-2 Chipset Overview 25
- 1-3 Special Features 26
- 1-4 PC Health Monitoring 26
- 1-5 ACPI Features 27
- 1-6 Power Supply 27
- 1-7 Super I/O 28
- Chapter 2 29
- Installation 29
- CLOSE 1st 30
- OPEN 1st 30
- Opening the LGA2011 Socket 31
- Removing the Heatsink 36
- 2-3 Installing DDR3 Memory 37
- Memory Support 38
- Memory Population Guidelines 39
- 2-4 Motherboard Installation 40
- Installing the Motherboard 41
- 2-5 Connectors/IO Ports 42
- 1. Keyboard (Purple) 43
- 2. Mouse (Green) 43
- (NC: No Connection) 45
- 3.IPMI Dedicated LAN 45
- Pin 19Pin 20 48
- A. 24-Pin ATX Main PWR 52
- B. 8-Pin Processor PWR 52
- (Required) 52
- A. Internal Buzzer 54
- B. Speaker Header 54
- C. Wake On LAN 54
- GLAN Enable 60
- Jumper Settings 60
- Pin#Denition 60
- 1-2 Enabled (default) 60
- 2-3 Disabled 60
- PCI-E Slot SMB Enable 61
- Short Enabled 61
- Open (Default) Disabled 61
- A. VGA Enable 62
- B. Watch Dog Reset 62
- A. USB 0/1 Wake-up 63
- B. BMC Enable/Disable 63
- A. ME Recovery 64
- B. ME Manufacturing Mode 64
- C. SAS Enable 64
- 2-8 Onboard Indicators 65
- A. Rear Unit ID LED 66
- B. IPMI Heartbeat LED 66
- C. Power LED 66
- 2-9 SATA and SAS Connections 67
- Chapter 3 69
- Troubleshooting 69
- No Video 70
- Memory Errors 70
- •Systemconguration 71
- Proper Battery Disposal 74
- Battery Installation 74
- Battery Removal 74
- Chapter 4 77
- 4-2 Main Setup 79
- BOOT Feature 80
- CPUConguration 81
- ChipsetConguration 84
- SATAConguration 87
- PCIe/PCI/PnPConguration 89
- SuperIODeviceConguration 90
- ACPI Settings 92
- Trusted Computing 93
- IntelTXT(LT-SX)Conguration 93
- ME Subsystem 94
- 4-4 Event Logs 96
- 4-5 IPMI 98
- 4-6 Boot Settings 100
- 4-7 Security Settings 101
- 4-8 Save & Exit 102
- Appendix A 105
- BIOS Error Beep Codes 105
- Appendix B 107
- B-2 ConguringSuperDoctor 108
- Appendix C 111
Verwandte Produkte und Handbücher für Server / Workstation-Motherboards Supermicro X9SRH-7F
(120 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.561 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern