Supermicro SuperChassis 836BA-R1K28B Bedienungsanleitung PDF herunterladen (Seite 59)

5-15

Chapter 5 Chassis Setup and Maintenance

Replacing the Front Panel

SC836 chassis models include a slim DVD-ROM, a drive bay for an optional pe-

ripheral drive and front port panel. Use the instructions in this section in the unlikely

event that you must replace any of these components.

Install the front

panel into the center

drive bay

Figure 5-10. Installing the DVD-ROM, Optional Peripheral Drive and Front Panel

Replacing or Installing the Front Port Panel

Installing the Front Panel

1. Power down the system and unplug the power cord.

2. Remove the chassis cover.

3. If you are not installing a new front port panel:

Remove the mini-bezel (grate) from the center drive bay The mini-bezel is the

small grating that covers the drive bay. Remove this by simply pulling it out of

the bay.

If you are installing a new front port panel:

Remove the old front port panel by depressing the release tab, then pulling

the front port panel out of the chassis.

4. Insert the new unit in the slot until the tab locks into place.

5. Connect the data and power cables to the backplane and, if necessary,

motherboard.

6. For more information, see the manual for your backplane in the appendix.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 143 144

Keine Kommentare

Supermicro SuperChassis 836BA-R1K28B Bedienungsanleitung Seite 59