Supermicro 2016Ti-HTRF Bedienungsanleitung PDF herunterladen (Seite 13)

Chapter 1: Introduction

1-5

1-4 2U Twin

: System Notes

As a 2U Twin

conﬁ guration, the 2016Ti-HTRF is a unique server system. With four

system boards incorporated into a single chassis acting as four separate nodes,

there are several points you should keep in mind.

Nodes

Each of the serverboards act as a separate node in the system. As independant

nodes, each may be powered off and on without affecting the others. In addition,

each node is a hot-swappable unit that may be removed from the rear of the chassis.

The nodes are connected to the server backplane by means of an adapter card.

System Power

The server has an additional 920W power supply module (two total) for power

redundancy. If a power supply module fails the other backup module will keep the

system running until it can be replaced.

SATA Backplane/Drives

As a system, the 2016Ti-HTRF supports the use of 24 SATA drives. A single back-

plane works to apply system-based control for power and fan speed functions,

yet at the same time logically connects a set of six drives to each serverboard.

Consequently, RAID setup is limited to a six-drive scheme (RAID cannot be spread

across all 24 drives). See the Drive Bay Installation/Removal section in Chapter 6

for the logical hard drive and node conﬁ guration.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 105 106

Keine Kommentare

Supermicro 2016Ti-HTRF Bedienungsanleitung Seite 13