Supermicro CSE-502L-200B Bedienungsanleitung PDF herunterladen (Seite 31)

6-1

Chapter 6: Rack Installation

Chapter 6

Rack Installation

6-1 Overview

This chapter provides a quick setup checklist to get your chassis up and running.

Following these steps in the order given should enable you to have the system

operational in a minimal amount of time.

6-2 Unpacking the System

You should inspect the box the chassis was shipped in, and note if it was damaged

in any way. If the chassis itself shows damage, you should le a damage claim with

the carrier who delivered it.

Decide on a suitable location for the rack unit that will hold your chassis. It should

be situated in a clean, dust-free area that is well ventilated. Avoid areas where

heat, electrical noise and electromagnetic elds are generated. You will also need

it placed near a grounded power outlet. Be sure to read the Rack and Server Pre-

cautions in the next section.

6-3 Preparing for Setup

The box your chassis was shipped in should include four mounting screws, which

you will need if you intend to install the system into a rack. Please read this section

in its entirety before you begin the installation procedure outlined in the sections

that follow.

Choosing a Setup Location

Leave enough clearance in front of the rack to enable you to open the front •

door completely (~25 inches).

Leave approximately 30 inches of clearance in the back of the rack to allow for •

sufcient airow and ease in servicing.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Keine Kommentare

Supermicro CSE-502L-200B Bedienungsanleitung Seite 31