Supermicro SSE-G48-TG4 Bedienungsanleitung PDF herunterladen (Seite 131)

5-103

Chapter 5: Web Based Management Utility

Multicast Filters

Clicking the MULTICAST FILTERS tab brings up the L2 MULTICAST FILTER CONFIGURATION

page (Figure 5-20), which allows you to set the filter configuration to control the

multicast packets that the switch needs to process. The parameters for this page are

shown in Table 5-13.

Figure 5-90. L2 Multicast Filter Configuration Page

Table 5-69. L2 Multicast Filter Configuration Page Parameters

Parameter Description

VLAN ID This parameter specifies the VLAN ID.

MAC Address This parameter specifies the destination MAC address of the received packet.

Receive Port This parameter specifies the port on which the packet was received.

Allowed Ports

This parameter specifies the list of ports on which the received packet, with the

above set MAC address (if received from the configured port) can be forwarded.

Forbidden Ports

This parameter specifies the list of ports on which the received packet, with the

above set MAC address (if received from the configured port) must NOT be

forwarded.

Status

You can choose to set this configuration to any one of the following types:

• Permanent – This configuration resides even after restart of the switch.

• DeleteOnReset – This configuration deletes the entry on restart.

• DeleteOnTimeout – This configuration deletes the entry on expiration of

the ageing timer.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 267 268

Keine Kommentare

Supermicro SSE-G48-TG4 Bedienungsanleitung Seite 131