Supermicro AS-1012G-MTF Bedienungsanleitung PDF herunterladen (Seite 36)

5-2

SUPERSERVER 1012G-MTF User's Manual

Unpacking

The motherboard is shipped in antistatic packaging to avoid electrical static

discharge. When unpacking the board, make sure the person handling it is static

protected.

5-2 Motherboard Installation

This section explains the ﬁ rst step of physically mounting the H8SGL-F into the

SC813MTQ-350 chassis. Following the steps in the order given will eliminate

the most common problems encountered in such an installation. To remove the

motherboard, follow the procedure in reverse order.

Installing to the Chassis

Access the inside of the system (see procedure in Chapter 6).1.

Make sure that the I/O ports on the motherboard align properly with their 2.

respective holes in the I/O shield at the back of the chassis.

Carefully mount the motherboard to the motherboard tray by aligning the 3.

board holes with the raised metal standoffs that are visible in the chassis. You

may need to add an extra standoff for the hole near the Fan 3 header.

Insert screws into all the mounting holes on your motherboard that line up 4.

with the standoffs and tighten until snug (if you screw them in too tight, you

might strip the threads).

Finish by replacing the top cover of the chassis.5.

Note: Metal screws provide an electrical contact to the serverboard ground to

provide a continuous ground for the system.

Warning: To avoid damaging the serverboard and its components, do not apply any

force greater than 8 lbs. per square inch when installing a screw into a mounting

hole.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 95 96

Keine Kommentare

Supermicro AS-1012G-MTF Bedienungsanleitung Seite 36