Supermicro AS-1012G-MTF Bedienungsanleitung PDF herunterladen (Seite 54)

5-20

SUPERSERVER 1012G-MTF User's Manual

VGA Enable/Disable

JPG1 allows you to enable or disable the

VGA port. The default position is on pins 1

and 2 to enable VGA. See the table on the

right for jumper settings.

VGA Enable/Disable

Jumper Settings (JPG1)

Jumper Setting Deﬁ nition

Pins 1-2 Enabled

Pins 2-3 Disabled

I2C to PCI-Express Slot

JI

2

C1/JI

2

C2 allows you to enable the I

2

C bus

to communicate with the PCI-Express slot.

For the jumpers to work properly, please set

both jumpers to the same setting. If enabled,

both jumpers must be enabled. If disabled,

both jumpers must be disabled. See the table

on the right for jumper settings.

I

2

C to PCI-Express Slot

Jumper Settings

(JI

2

C1/JI

2

C2)

Jumper Setting Deﬁ nition

Closed Enabled

Open Disabled

LAN1/2 Enable/Disable

Change the setting of jumper JPL1 or JPL2

to enable or disable the LAN1 or LAN2

Ethernets port. See the table on the right

for jumper settings. The default setting is

enabled.

LAN1/2 En/Disable Jumper

Settings (JPL1/JPL2)

Jumper Setting Deﬁ nition

Pins 1-2 Enabled

Pins 2-3 Disabled

Onboard Speaker Enable/Disable

The JD1 header allows you to use either an

external speaker or the internal (onboard)

speaker. To use the internal onboard speaker,

close pins 6 and 7 with a jumper. To use an

external speaker, remove the jumper and

connect the speaker wires to pins 4 (+5V)

and 7 (control signal). See the table on the

right for settings and the table associated with

the Power LED/Keylock/Speaker connection

(previous section) for jumper settings.

Onboard Speaker Enable/Disable

Pin Deﬁ nitions (JD1)

Pins Deﬁ nition

6 and 7 Jump for onboard speaker

4 and 7 Attach external speaker wires

Note: Pins 4-7 are used only for

the onboard speaker.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 95 96

Kommentare zu diesen Handbüchern

Keine Kommentare