Supermicro Processor Blade SBI-7127R-SH Bedienungsanleitung PDF herunterladen (Seite 43)

3-11

Chapter 3: Setup and Installation

Note: For an optimized memory bandwidth, it is recommended that you populate the

memory modules in sets of four (4) DIMMs for the CPU’s.

DIMM Installation

Caution: Exercise extreme care when installing or removing DIMM modules to prevent any

possible damage.

Installing DIMM Memory Modules

1. Power down the blade module (see "Powering Down a Blade Unit" on page 3-1).

2. Remove the blade from the enclosure and the cover from the blade (see

"Removing/Replacing the Blade Cover" on page 3-2).

3. Remove the air shroud that covers the DIMM slots.

4. Insert each DIMM vertically into its slot, starting with slots A1 and A2. Pay attention

to the notch along the bottom of the module to prevent inserting the DIMM

incorrectly (see Figure 3-14).

5. Gently press down on the DIMM until it snaps into place in the slot. Repeat for all

modules (see Table 3-1 for installing DIMMs into the slots in the correct order).

6. Replace the air shroud and the blade cover and install the blade module back into

the enclosure.

7. Power up the blade unit (see "Powering Up a Blade Unit" on page 3-1).

Figure 3-14. Installing a DIMM into a Memory Slot

To Install: Insert module vertically

and press down until it snaps into

place. Pay attention to the bottom

notch.

To Remove: Use your thumbs to

gently push each release tab

outward to free the DIMM from the

slot.

Note: The notch should align with

the receptive key point on the slot.

Side View

Top View

Notch

Release Tabs

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 89 90

Keine Kommentare

Supermicro Processor Blade SBI-7127R-SH Bedienungsanleitung Seite 43