Supermicro SYS-7046A-6 Bedienungsanleitung PDF herunterladen (Seite 66)

6-8

SuperWorkstation 7046A-6 User's Manual

Installing Components in the 5.25" Drive Bays

The 7046A-6 has three 5.25" drive bays. Components such as SATA hard drives or

DVD/CD-ROM drives can be installed into these 5.25" drive bays.

Removing the Empty Drive Bay

First power down the system.1.

Remove the top/left chassis cover to access the drive components.2.

With the cover off, remove the screws that secure the drive carrier to the 3.

chassis (one side only) then push the entire empty drive carrier out from the

back.

Adding a DVD/CD-ROM Drive

Remove the guide plates (one on each side) from the empty drive carrier 1.

and screw them into both sides of the DVD/CD-ROM drive using the holes

provided.

Slide the DVD/CD-ROM into the bay and secure it to the chassis with the 2.

drive carrier screws you ﬁ rst removed.

Attach the power and data cables to the drive.3.

Replace the top/left chassis cover and restore power to the system.4.

Adding a SATA Drive

Install an SATA drive into one of the removed empty drive carriers.1.

Secure the drive to the carrier with screws then slide the assembly into 2.

the bay and secure it to the chassis with the drive carrier screws you ﬁ rst

removed.

Attach the power and data cables to the drive.3.

Replace the top/left chassis cover and restore power to the system.4.

Note: Drive carriers should remain in any empty drive bays to maintain proper

airﬂ ow within the chassis.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 97 98

Keine Kommentare

Supermicro SYS-7046A-6 Bedienungsanleitung Seite 66