Supermicro SYS-7047GR-TPRF Bedienungsanleitung Seite 15
- Seite / 114
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 2: Workstation Installation
2-1
Chapter 2
Workstation Installation
2-1 Overview
This chapter provides a quick setup checklist to get your SuperWorkstation 7047GR-
TPRF up and running. Following the steps in the order given should enable you
to have the system operational within a minimal amount of time. If your system is
not already fully integrated with a motherboard, processor, system memory etc.,
please turn to the chapter or section noted in each step for details on installing
specic components.
2-2 Unpacking the System
You should inspect the box the SuperWorkstation 7047GR-TPRF was shipped in
and note if it was damaged in any way. If the workstation itself shows damage, you
should le a damage claim with the carrier who delivered it.
Decide on a suitable location for setting up and operating the SuperWorkstation
7047GR-TPRF. It should be situated in a clean, dust-free area that is well ventilated.
Avoid areas where heat, electrical noise and electromagnetic elds are generated.
You will also need it placed near a grounded power outlet.
!
!
Warnings and Precautions!
•Review the electrical and general safety precautions in Chapter 4.
• Use a regulating uninterruptible power supply (UPS) to protect the workstation
from power surges, voltage spikes and to keep your system operating in case
of a power failure.
•Allow the power supply units and Serial ATA drives to cool before touching
them.
•To maintain proper cooling, always keep all chassis panels closed when not
being serviced.
- SUPER 1
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 4 System Safety 7
- Chapter 1 9
- Introduction 9
- 1-2 Serverboard Features 10
- 1-3 Chassis Features 11
- 1-4 GPU Subsystem 12
- Chapter 1: Introduction 13
- System Block Diagram 13
- 1-5 Contacting Supermicro 14
- Chapter 2 15
- Workstation Installation 15
- 2-3 Preparing for Setup 16
- Warnings and Precautions! 16
- Rack Mounting Considerations 17
- Reliable Ground 18
- Chassis Cover 19
- Chassis Feet 19
- Chassis Cover Lock 19
- Chassis Handle 20
- Inner Rails 20
- Slide into the Inner Rail 21
- Secure to the 21
- Rear of the Rack 21
- Attach to Middle Rail 21
- Installing the Chassis Cover 23
- Chassis Foot 24
- Receptacle 24
- Chassis Screw 24
- Chapter 3 25
- System Interface 25
- 3-2 Control Panel Buttons 26
- 3-3 Control Panel LEDs 26
- Overheat/Fan Fail 27
- Power Fail 27
- 3-4 Drive Carrier LEDs 28
- Chapter 4 29
- System Safety 29
- 4-3 ESD Precautions 31
- 4-4 Operating Precautions 32
- Chapter 5 33
- Advanced Serverboard Setup 33
- •Control Panel cable (JF1) 34
- 5-3 I/O Ports 35
- OPEN 1st 36
- WARNING! 36
- 5-6 Installing Memory 40
- 5-6 Adding PCI Add-On Cards 44
- 5-7 Serverboard Details 45
- 5-8 Connector Denitions 47
- LAN1/2 Enable/Disable 54
- Jumper Settings 54
- Pins 1-2 Enabled 54
- Pins 2-3 Disabled 54
- 5-10 Onboard Indicators 56
- 5-11 SATA Ports 57
- 5-12 Installing Software 58
- Supero Doctor III 59
- Chapter 6 61
- Advanced Chassis Setup 61
- 6-1 Static-Sensitive Devices 62
- 6-2 Control Panel 62
- 6-3 System Cooling 63
- FAN-0116L4 65
- 6-4 Power Supply 66
- Power Supply Connections 67
- Tower or Rack Conguration 68
- Rotating the Storage Module 69
- Removing a Drive Carrier 71
- Hard Drive 72
- Hard Drive Tray 72
- Adding Peripheral Drives 73
- Drive Tray Handle 74
- Release Button 74
- Drive Tray 75
- SAS/SATA 75
- Chapter 7 77
- 7-2 Main Setup 78
- Boot Features 80
- •Type of CPU 81
- •CPU Signature 81
- •Microcode Patch 81
- Chipset Conguration 86
- North Bridge 86
- Integrated IO Conguration 86
- QPI Conguration 87
- DIMM Conguration 88
- DIMM Information 88
- South Bridge Conguration 90
- SATA Conguration 91
- PCIe/PCI/PnP Conguration 92
- Super IO Conguration 94
- Serial Port 1 Conguration 94
- Serial Port 2 Conguration 94
- Console Redirection Settings 95
- Console Redirection Settings 97
- ACPI Settings 97
- TPM Enable Status 98
- •ME BIOS Interface Version 99
- •ME Version 99
- NIC Conguration 100
- 7-4 Event Logs 101
- 7-5 IPMI 103
- BMC Network Conguration 104
- 7-6 Boot 105
- 7-7 Security 106
- 7-8 Save & Exit 107
- Appendix A 109
- BIOS Error Beep Codes 109
- Appendix B 111
- System Specications 111
Verwandte Produkte und Handbücher für Server Barebones Supermicro SYS-7047GR-TPRF
(74 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.073 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern