Supermicro SYS-8016B-6F Bedienungsanleitung PDF herunterladen (Seite 39)

Chapter 5: Advanced Serverboard Setup

5-7

Installing the Heat Sink Installation

Do not apply any thermal grease to the 1.

heat sink or the CPU die; the required

amount has already been applied.

Place the heatsink on top of the CPU so 2.

that the four mounting holes are aligned

with those on the retention mechanism.

Screw in two diagonal screws until just 3.

snug (do not over-tighten the screws,

which may damage the CPU.)

Finish the installation by fully tightening all 4.

four screws.

Warning: We do not recommend removing the CPU or the heat sink.

However, if you do need to uninstall the heat sink, please follow these

instructions to avoid damaging the CPU or the CPU socket.

Installation and Removal of the Heat Sink

Removing the Heat Sink

Unscrew and remove two diagonal heat 1.

sink screws and then the reamaining two

diagonal screws.

Hold the heat sink and 2. gently wriggle

to loosen it from the CPU. (Do not use

excessive force when doing this!)

Once the heat sink is loosened, remove it 3.

from the CPU socket.

Clean the surface of the CPU and the 4.

heat sink to get rid of the old thermal

grease. Reapply the proper amount of

thermal grease before you re-install the

heat sink.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 105 106

Keine Kommentare

Supermicro SYS-8016B-6F Bedienungsanleitung Seite 39