Supermicro 1022G-URF Bedienungsanleitung PDF herunterladen (Seite 59)

Chapter 5: Advanced Serverboard Setup

5-25

After exiting the BIOS Setup Utility, the system will reboot. When prompted 1.

during the startup, press the <CTRL+A> key when prompted to run the Dot-

Hill RAID Utility program (see Figure 5-6).

Figure 5-6.Adaptec RAID Utility Program Screen

Using the Adaptec RAID Utility

The Adaptec® RAID Utility program is where you can deﬁ ne the drives you want

to include in the RAID array and the mode and type of RAID.

Installing the RAID Driver During OS Installation

You may also use the procedure below to install the RAID driver during the Window's

OS installation:

With the Windows OS installation CD in the CD-ROM drive, restart the 1.

system.

When you see the prompt, hit the <F6> key to enter Windows setup.2.

Eventually a blue screen will appear with a message that begins "Windows 3.

could not determine the type of one or more storage devices . . ." When you

see the screen, hit the <S> key to "Specify Additional Device", then insert the

driver diskette you just created into the ﬂ oppy drive.

Highlight "Manufuacturer Supplied Hardware Support Disk" and hit the 4.

<Enter> key.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 94 95

Keine Kommentare

Supermicro 1022G-URF Bedienungsanleitung Seite 59