Supermicro SuperWorkstation 5037A-i Bedienungsanleitung PDF herunterladen (Seite 45)

Chapter 5: Advanced Serverboard Setup

5-23

LAN Port Enable/Disable (JPL2)

Jumper JPL2 enables or disables LAN

Port 2 on the motherboard. See the table

on the right for jumper settings. The de-

fault setting is pins 1-2 (Enabled).

GLAN Enable

Jumper Settings

Pin# Denition

1-2 Enabled (default)

2-3 Disabled

Watch Dog Reset (JWD1)

Watch Dog (JWD1) is a system monitor

that can reboot the system when a soft-

ware application hangs. Close Pins 1-2 to

reset the system if an application hangs.

Close Pins 2-3 to generate a non-mask-

able interrupt signal for the application

that hangs. See the table on the right for

jumper settings. Watch Dog must also be

enabled in the BIOS.

Watch Dog

Jumper Settings

Jumper Setting Denition

Pins 1-2 Reset (default)

Pins 2-3 NMI

Open Disabled

TPM Support Enable (JPT1)

JPT1 allows the user to enable TPM (Trust-

ed Platform Module) support to improve

data integrity and system security. See the

table on the right for jumper settings. The

default setting is Enabled.

TPM Support Enable

Jumper Settings

Jumper Setting Denition

1-2 (Default) Enabled

2-3 Disabled

CF Slave/Master

Jumper Settings

Jumper Setting Denition

Open Slave

Closed Master

CF Card Master/Slave (JCF1)

A Compact Flash Card Master/Slave Se-

lect Jumper is located at JCF1. Close this

jumper to enable Compact Flash Card. For

the Compact Flash Card or the Compact

Flash Jumper (JCF1) to work properly, you

will need to connect the Compact Flash-

Card power cable to JWF1 rst. Refer tothe

board layout below for the location.

A. TPM Support Enable

B. CF Card Master/Slave Select

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 101 102

Kommentare zu diesen Handbüchern

Keine Kommentare