Supermicro 1012C-MRF Bedienungsanleitung PDF herunterladen (Seite 65)

Chapter 6: Advanced Chassis Setup

6-5

Replace the top cover when ﬁ nished. See Figure 6-3.6.

Note: the 1012C-MRF can accommodate two internal SATA hard drives, one on

each side of the fans.

Enterprise level hard disk drives are recommended for use in Supermicro

chassis and servers. For information on recommended HDDs, visit the

Supermicro Web site at http://www.supermicro.com/products/nfo/storage.

cfm

DVD-ROM Drive Installation/Removal

The top cover of the chassis must be opened to gain full access to the DVD-ROM

drive bay. The DVD-ROM must have a "slim" proﬁ le to ﬁ t into the 1012C-MRF. If

you cannot remove the top cover with the system remaining in the rack, follow the

procedure below.

DVD-ROM Drive Installation

First shutdown the system and disconnect the AC power cable.1.

Make sure the system is supported from underneath then remove the front 2.

bracket screws that secure the unit to the rack.

Carefully lift the server out of the rack.3.

Open the cover by removing the screws from the lips on either side of the 4.

cover then depress the two buttons on the cover to release it.

Push the cover away from you then lift it from the chassis to gain full access 5.

to the inside of the server..

Insert the DVD-ROM inside the chassis and then secure it with screws to the 6.

chassis.

Replace the top cover when ﬁ nished and reinstall the server into the rack.7.

Note: A red mark on a ribbon cable typically designates the location of pin 1.

DVD-ROM Drive Removal

First shutdown the system and disconnect the AC power cable.1.

Make sure the system is supported from underneath then remove the front 2.

bracket screws that secure the unit to the rack.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 91 92

Keine Kommentare

Supermicro 1012C-MRF Bedienungsanleitung Seite 65