Supermicro SuperServer 8047R-TRF+ Bedienungsanleitung PDF herunterladen (Seite 50)

5-10

SUPERSERVER 8047R-TRF+/7RFT+ USER'S MANUAL

5-5 Installing Memory

Caution! Exercise extreme care when installing or removing DIMM modules to prevent

any possible damage.

Memory Support

The X9QRi-F+/X9QR7-TF+ has thirty-two (32) 240-pin DIMM sockets that can

support up to 1024GB of Registered (RDIMM), Load Reduced (LRDIMM) ECC

or Unbuffered (UDIMM) ECC/Non-ECC DDR3 1600/1333/1066/800 MHz speed

SDRAM in a two-channel memory bus. Memory sizes of

1GB, 2GB, 4GB, 8GB, 16GB and 32GB size @ 1.35V/1.5V voltage are supported.

Use memory modules of the same type, speed, timing and same on a serverboard.

Please refer to the product page on our web site for possible updates to memory

support.

Note: See the table belows for memory installation.

Installing Memory Modules (Figure 5-3)

1. Insert the desired number of DIMMs into the memory slots, starting with P1-

DIMM #A1. The release tabs on the slot should be pushed outward.

2. Insert each DIMM module vertically into its slot. Pay attention to the notch

along the bottom of the module to avoid installing incorrectly (see Figure 5-3).

3. Gently press down on the DIMM module until it snaps into place in the slot.

Make sure that the side notches of the DIMM modules align with the lock/

release tabs of the slot when pressed in. Repeat for all modules.

4. Reverse the steps above to remove the DIMM modules from the serverboard.

Lock/Release Tabs

Notches

Release

Figure 5-3. Installing DIMMs

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 121 122

Keine Kommentare

Supermicro SuperServer 8047R-TRF+ Bedienungsanleitung Seite 50